In the Maker Shed: Gakken Stirling Engine Kit
This week I made the Gakken Stirling Engine Kit from the Maker Shed. It's a really nice kit, in fact it's my new favorite kit made by ...
Inside a Stirling Engine Andy Ross Stirling Engine Kit Design
This is the Andy Ross engine that ran in the test. The Displacer piston popped loose so I did a video on the internal parts of the video. Bit long ...
gakken_stirling_part_1.m2ts
A review of the Stirling Engine kit from Gakken's Otona no Kagaku series. This is part 1 of 3 of a little video series that I tried creating ...
Demonstration of wood burning Stirling engine
Single cylinder rhombic drive engine, atmospheric working pressure. Stroke 150mm bore 70mm. Heater multi stainless steel tubing. Cooler multi ...
All the parts assembled apart from the smaller secondary piston.
The flywheel on its hub, in place on some very nice dinky little bearings.
All the parts you get in the KS80 kit. The instructions are good, and the engineering is startlingly precise, so putting all these little bits together is quite easy. Even if you're the sort of hamfisted idiot who can get through three different push-fit connectors in one weekend and still not...
My kids and I building the Gakken "Otono no Kagaku" Vol. 10 Stirling Engine Kit
The displacer (foam rubber) to the left, and main cylinder to the right. The round thing in the main cylinder is a soft rubber membrane that will act as the power cylinder.